What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?
08.06.2025 09:46

One is “what exactly is in a ‘surge protector’ ? ”
So, it’s possible that these devices from Trip Lite have addition suppression devices, these ones seem to be sturdy.
Edit 2024–10.
This is where the MOV conducts again, and dissipated the energy.
the problem then depends on "how fast does the fuse operate?".
There are three different concepts here that are getting confused.
So combined with a device called a MOV or Metal-oxide-resistor, then forms the 3rd part of a “surge suppressor “.
But during the surge, the fuse will not blow if it is a longer duration and lower value )10 to 50%).
OK, this is Mohan Rajaratnam’s definition of a Surge suppressor.
If my lovely sister sleeps with my boyfriend, what should I do about her?
2024–10–10[John johnson John Johnson ]
If the nominal power is 4,000 watts then the current at 230volts is 16 amps.
“ A surge suppressor is the one which is connected at the input supply so that when there is a sudden change voltage it bypasses thereby protecting the (circuit) and electronic components”
What is lightning?
What does a fuse do?
Once the voltage goes over 0.0650 volts, then this fact can be used to amplify the difference, and turn the circuit breaker off , furthur down the line. Essentially that is what a RCD/GFCI does, it compares the incoming current, to the outgoing current, and if the difference between the two currents is over 5mA, then it trips the circuit breaker.
what exactly is a ‘surge’ protector?
2024–10–14 [Omar Gharbi Omar Gharbi ]
The third is lightning and “how it gets conducted into a home.”
Lexi Wood Exits Bravo’s ‘Summer House’ After 1 Season - Deadline
This is where this question deviates from being a 'generic' question, and becomes more specific.
(Dc diagram shown, AC is similar).
And this is the problem alone. Is the power supply in the equipmemt designed with a lightning strike in mind? Some yes, others, no.
New Videos Show How Fantasy Life i Has Been Beefed Up On Switch 2 - Nintendo Life
2024–10–11 [Victor Olarewsju Victor Olarewaju ]
a photo is worth a thousand words.
This is a photo where a lightning bolt took out a home's complete mains distribution box, and a lot of electronic gear as well.
Liberals, why don't you like Conservatives?
Barnstars:
An AC voltage/ current source, and an ac inductive load.
It’s been three xxx five werks, and there has been no response to my follow on query on his Commment to my answer.
Rare ‘Einstein zig-zag’ sheds light on universe’s hidden forces - The Brighter Side of News
so, what happens?
“ … to protect building, lightning arrestor, is provided above building and directly connected to earth.”
It seems Mohan does not understand the difference between a comment and an Answer.
Massive iron reserve worth trillions discovered could reshape the global economy - Glass Almanac
This device then solves the entire problem.
A fuse is a non-resetable over current circuit protector.
but this device (an Inductor) … impedes the rapid changes in the current.
Why are there so many single moms in America?
eight
Now when you have a certain ac resistance, then a current flows in a loop.
This is a high voltage low current spike that comes down the line because of the power poles being struck, and the voltage suppressors activating on the primary side of the transformer.
In schematic diagrams this is the symbol for a fuse:
He then describes Rainy Season and Lightning.
“ A fuse is a device which protects the (circuit) against overload and short circuit.”
These devices are installed between the “hot” and “neutral” and protective ground.
One
(There is no concept of polarity, in the loop because the current changes direction 100 to 120 times a second (power frequency).
[old diagram got deleted by accident]
I post the exact comment here.
This is 'the assistant's answer'
so, the loop of wire then, when put together with another loop reduces the ‘noise’ on a power line.
2024–10–00 [ Ammar Mahdi ] Ammar Mahdi
This is an electronic circuit designed to clamp voltages so that the Voltage Potential that appears at the outlet is never going to exceed the nominal value.
Upvotes:
Is the question then , "why buy a surge supressor, if the fuse alone protects the electronic circuits from a lightning bolt?".
There is no harm in having the surge suppressor along with the fuse in the circuit. The fuse will not open up until the current melts the link. This will take time, and in the interim, that jolt will get transmitted into the power supplies.
[image of Common-mode choke]
At one ohm, the resistor has a maximum of 1 watt power.
At the secondary, it is 1000 times less.)turns ratio). If it gets hit with a 100,000 volt bolt of lightning then the voltage arrestors conduct and clamp the voltage down to line voltage, ( but a small amount leaks down the line). This is the problem.
But… the neutral is now “floating” because of the 1 ohm resistance.
At least they know the answer if they wanted it.
Because the load is inductive, the current lags the voltage.(by a bit).
This one hit behind the barn.
Can the fuse protect the electronic devices from lightning instead of a surge protector.
When the current is 200% of the rated value , it will “go open” (the link metal melts) and protect the device.
The bolt then partially travels down the line to your home.
Mohan forgets that a fuse is a one-time device, and needs to be replaced if it is tripped.
These are simplified answers to the original question, and does not change anything I wrote above.
It also is a device that limits the change in current flow.
The MOV will conduct when the voltage exceeds 50% of line voltage.
Fuses, on their own, then operate much slower than the MOV variable resistance, during the lightning strike.
He then asserts :
but I think this circuit , shows a few more pieces.
nine
He then describes the function of a fuse.
For this case there are devices called Metal oxide varistors (MOV).
Lightning arrestor is a spark-gap device, and can be installed anywhere. What is important, is that the wire is thick enough to withstand the lightning bolt and conduct the energy away from the building.
So, the voltage could go up to 500 volts, and the fuse will not open up.
P = e* I, so since I is 16 amps, then the voltage dropped is 1/16 volt or 0.0650 volts.
A circuit breaker is similar, but is resettable.
2024–09–27 [ Mohan Rajaratnam Mohan Rajaratnam ] . Thinks you can get free electricity from nothing : Mohan Rajaratnam's answer to Is it possible to generate free electricity at home using a magnet or other low-cost methods? If so, how does it work?
This is the picture of an electronic coil of wire wound around a core of magnetic material.
Here is a simplified AC power diagram.
But it can get overloaded, and no longer works.
Would individual surge supressors have save this equipment? most likely, since the surge supressor would take the jolt instead of the electronic components.
The other is “what does a “fuse” do?”
There are two important concepts here.
First Sentence:
2024–10–11 [Bobby Sanchez Bobby Sanchez ].
2024–10–16 [ OO OLAOYE OYEBODE ]